BI-WELDER TIG 2040 DC-HF is a single-phase inverter power source for TIG and MMA-SMAW use, not including AWS6010 cellulosic electrodes, designed for maintenance work and small production batches.
The machine may work with pulsed arc, for use on thin workpieces where heat transfer must be minimal and is set up for remote control using the foot control (art. 193), remote control (art. 187), or up-down command on the torch.
The following gases may be used for protection:
- argon
- argon/helium
- hydrogen argon
In TIG mode, the arc is started either in high frequency or by contact with the Cebora lift system. It is also possible to save up to 9 welding programs in memory.
The compliance with EN 61000-3-12 brings substantial energy saving and a wide supply voltage tolerance (+15% / -20%).
The power source can be powered by motor generators of adequate power (Min. 6 KVA).
